March 26, 2014

Yellow Polka Dot Bikini...Cup Covers

Now that the bikini bottoms are almost finished, it is time to start the cups. For this classic retro-styled bikini, I am using the MT triangle cups from Bra-makers Supply. These cups are made of a denser foam that stands up to having fabric pulled over it without collapsing. That's the worst - when the cup collapses! The cups are chlorine-resistant, of course!



Lay the fabric right side up over the foam and cut roughly around the cup perimeter so you have a more reasonable amount of fabric to work with. Start pinning at the top and smooth the fabric to the bottom corners. You will notice an excess of fabric in the middle bottom of the cup. That is completely normal and the amount of excess will depend on the amount of stretch in your chosen fabric.

Pin out the excess fabric and form 3 small pleats (or 5 or 7 - even numbers are best).





Alternately, if you lay the fabric on the cup upside down, you can pin out a dart over the cup. It is very easy to do and has a more tailored look. Yes, the dart is curved, even when pinning.



Mark the dart and the perimeter of the cup with a wash-out marker.



Remove the fabric carefully from the cup (you won't have to remove the fabric if you are doing the pleasted version). 



Stitch the dart, tapering to virtually nothing at the point of the dart. This will prevent the dart from "pooking". Trim the dart seam allowance and pin the fabric back on the cup, smoothing out any wrinkles.

Zig-zag around the perimeter of the cup, stitching from the foam side. This will prevent the fabric from creeping and creating bias wrinkles. Trim off the excess fabric.



Now you have to make the second cup look symmetrical and even with the first!



Next time, I will share how to make elasticated straps!




1 comment:

  1. Hermosa la explicación para hacer un corpiño de malla..gracias por explicarlo tan claro..abrazos desde Argentina y gracias x publicar

    ReplyDelete